Fujitsu FLASH-CAN2-100P-M06 Посібник користувача - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник користувача для Материнська плата Fujitsu FLASH-CAN2-100P-M06. Fujitsu FLASH-CAN2-100P-M06 20 сторінок. F²mc-16lx family

Друкувати сторінку

5 Configuration of the Evaluation-Board

The board is configured to work with the MB90F598 microcontroller.
In order to set up the board follow these steps:
1. disconnect power supply disconnected !
2. Set jumper JP1 to provide Vcc, i.e. 5V to the board
3. If case one is connecting this board to an emulator, it is recommended to set jumper JP2
in order to provide 3.7V to the internal core.
4. Please set the mode pins 1-3 on S3 according to your MCU operating mode. ON stands
for 0 and OFF for 1. E.g. MB90F598 all switches to OFF except no. 3.
5. Adjust both potentiometers (P1, P2) clockwise to their end position.
(Check that Pin 8 of U4 and Pin 8 of U5 are grounded.)
6. Select the appropriate CAN interface for the microcontroller you are using by setting
jumper JP3-JP6. Note that Pixx on the silk plot stands for Pinxx, i.e. the pin number.
E.g. for the MB90F598, set JP3 and JP4 to connect Pin 2 and 3 in order to connect to
MCU Pins 74 and 75, respectively.
Target
Series
MB90425
MB90440
MB90470
MB90540
MB90545
MB90550
MB90583
MB90590
MB90595
Table 1: Microcontroller pin-number of the CAN-interface
UG-900001-32
Change even page title here
Chapter 5 Configuration of the Evaluation-Board
CAN0
RX0
TX0
RX1
Pin 75
Pin 74
n.a.
Pin 74
Pin 73
Pin 76
n.a.
n.a.
n.a.
Pin 74
Pin 73
Pin 76
Pin 74
Pin 73
n.a.
n.a.
n.a.
n.a.
n.a.
n.a.
n.a.
Pin 75
Pin 74
Pin 97
Pin 75
Pin 74
n.a.
- 10 -
CAN1
CAN2
TX1
RX2
n.a.
n.a.
Pin 72
Pin 75
(Not supported by
Jumper 3-6 !)
n.a.
n.a.
Pin 75
n.a.
n.a.
n.a.
n.a.
n.a.
n.a.
n.a.
Pin 98
n.a.
n.a.
n.a.
© Fujitsu Microelectronics Europe GmbH
TX2
n.a.
Pin 71
n.a.
n.a.
n.a.
n.a.
n.a.
n.a.
n.a.