Fujitsu FLASH-CAN2-100P-M06 사용자 설명서 - 페이지 14
{카테고리_이름} Fujitsu FLASH-CAN2-100P-M06에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu FLASH-CAN2-100P-M06 20 페이지. F²mc-16lx family
페이지 인쇄6 Using the Asynchronous Boot-Loader
The asynchronous boot-loader SW from Fujitsu can be used to program a blank flash
microcontroller. This tool is available on the floppy disc. The following additional steps to
chapter 5 need to be taken to set up the hardware (power supply disconnected!):
1. Place the flash microcontroller in its socket (observe pin no. 1 position).
2. Set DIP switch (SW3) :
1,5,7,8
ON
2,3,4,6
OFF
MB90470 / MB90480 series only:
1,5
ON
2,3,4,6,7,8
OFF
additionally Pin 47 and 48 (Port P80,P81) have to be connected to GND
for MB90470 and MB90480 series only (see chapter 5.1)
3. Switch on the power supply.
4. Start the asynchronous boot loader software and follow the instructions.
5. Set DIP switch (SW3)
for RUN-Mode,
e.g. Single-Chip-Mode
3
ON
1,2,4,5,6,7,8 OFF
MB90470 / MB90480 series only:
disconnect Pin 47 and 48 (Port P80,P81) from GND (see chapter 5.1)
6. Reset Target
UG-900001-32
Change even page title here
Chapter 6 Using the Asynchronous Boot-Loader
8
8
8
- 14 -
7
6
5
4
3
7
6
5
4
3
7
6
5
4
3
© Fujitsu Microelectronics Europe GmbH
2
1
OFF
ON
2
1
OFF
ON
2
1
OFF
ON