Fujitsu FLASH-CAN2-100P-M06 사용자 설명서 - 페이지 15

{카테고리_이름} Fujitsu FLASH-CAN2-100P-M06에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu FLASH-CAN2-100P-M06 20 페이지. F²mc-16lx family

7 Connectors

The following figure shows the power connection jack X1. This connector is used to connect

an external unregulated DC power supply voltage (9V-12V DC) to the evaluation board.

Connector X1:

It is recommended to use 9V to keep the power dissipation to a minimum. Otherwise, an

additional heat sink for the linear voltage regulator might be necessary.

All pins of the microcontroller (QFP-100 package) are directly connected to J2, J3, J4 and

J5, all are 2 x 25 Pin headers, as follows:

Connector

J2, J4 (1 – 50)

J3, J5 (51 – 100)

The odd pin numbers are located on the one side and the even pin numbers are located on

the other side of the connector.

On the PCB, the corresponding pin numbers of the TC are written next to the connector pins.

Additionally Vcc and GND Pins

are placed on the board (JP11).

Change odd page title here

Chapter 7 Connectors

Shield is connected to positive voltage supply

Centre is connected to ground (GND)

MCU Pins

1 – 50

51 – 100

Vcc 1

Vcc 3

Vcc 5

Vcc 7

Vcc 9

- 15 -

2 GND

4 GND

6 GND

8 GND

10 GND

Pinning of JP11

UG-900001-32