Fujitsu FLASH-CAN2-100P-M06 Benutzerhandbuch - Seite 15

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Hauptplatine Fujitsu FLASH-CAN2-100P-M06 herunter. Fujitsu FLASH-CAN2-100P-M06 20 Seiten. F²mc-16lx family

7 Connectors

7.1 Power connector (X1)

The following figure shows the power connection jack X1. This connector is used to connect
an external unregulated DC power supply voltage (9V-12V DC) to the evaluation board.
Connector X1:
It is recommended to use 9V to keep the power dissipation to a minimum. Otherwise, an
additional heat sink for the linear voltage regulator might be necessary.

7.2 Edge connector (J2, J3, J4, J5)

All pins of the microcontroller (QFP-100 package) are directly connected to J2, J3, J4 and
J5, all are 2 x 25 Pin headers, as follows:
Connector
J2, J4 (1 – 50)
J3, J5 (51 – 100)
The odd pin numbers are located on the one side and the even pin numbers are located on
the other side of the connector.
On the PCB, the corresponding pin numbers of the TC are written next to the connector pins.

7.3 GND/VCC (JP11)

Additionally Vcc and GND Pins
are placed on the board (JP11).
© Fujitsu Microelectronics Europe GmbH
Change odd page title here
Chapter 7 Connectors
Shield is connected to positive voltage supply
Centre is connected to ground (GND)
MCU Pins
1 – 50
51 – 100
Vcc 1
Vcc 3
Vcc 5
Vcc 7
Vcc 9
- 15 -
2 GND
4 GND
6 GND
8 GND
10 GND
Pinning of JP11
UG-900001-32