Fujitsu MB91360 SERIES 사용자 설명서 - 페이지 8

{카테고리_이름} Fujitsu MB91360 SERIES에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu MB91360 SERIES 43 페이지. Levelshifter board
Fujitsu MB91360 SERIES에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지), 애플리케이션 노트 (35 페이지), 사용자 설명서 (20 페이지)

페이지 인쇄

STARTERKIT MB91360

Chapter 1 Introduction

1.4 Mode Selection

The board has three different "modes", which are represented by the three reset-buttons

"USER", "FLASH" and "MONITOR".

By default, the board will startup in the "MONITOR"-mode, which automatically invokes the

debugger kernel. The board now can communicate with Softune Workbench. This means,

any application can be downloaded and debugged with all provided features such as

breakpoints, watches, single step etc. (see chapter "Softune Debugging Features").

Once any code has been downloaded to SRAM, the application can also be executed

directly from a "USER" reset. The application will run without any intervention from the host

(e.g. breakpoints). This mode should mainly be used to test the application before

programming the entire contents to flash.

If finally the application has been transferred to flash-ROM, execution can start from the

flash-ROM using the "FLASH"-reset. This is the stand-alone mode for any user application.

As a last step, the board can be configured to start directly in the "FLASH"-mode after

power-on (by jumper JP34). This allows creating of a "real" stand-alone application.

UG-910006-13

- 8 -