Fujitsu MB91460 SERIES 시작하기 - 페이지 35

{카테고리_이름} Fujitsu MB91460 SERIES에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu MB91460 SERIES 41 페이지. 32-bit microcontroller
Fujitsu MB91460 SERIES에 대해서도 마찬가지입니다: 사용자 설명서 (45 페이지), 애플리케이션 노트 (23 페이지), 애플리케이션 노트 (26 페이지), 애플리케이션 노트 (29 페이지), 애플리케이션 노트 (29 페이지)

페이지 인쇄
Fujitsu MB91460 SERIES 시작하기
Chapter 7 Setup / Change Connection PC – Emulation System
•
A Fujitsu support engineer can easily help solving a concrete problem by debugging
your application out of a Fujitsu support centre.
•
You can control the emulator from different locations without having to move your
hardware installation from one place to another.
•
Program download will be more than 6 times faster than with RS232C

7.3.2 Configuring the LAN Adapter

1. Connect emulator and PC by the serial RS232-Port (or USB-Port)
3
Start the „LAN Address" Program in the Softune Workbench Folder
4
Click on Communication to define the serial RS232 Port where the emulator is
connected to or use USB connection.
5
Read current status from the emulator
6
Set the unique IP address given from your network manager. This is a very important
point; every IP-address within a network has to be unique.
7
Check the Port address: must be 5001
8
Make settings valid by „Set", and reset the emulator when prompted
9
Close Program „LAN Address"
© Fujitsu Microelectronics Europe GmbH
Getting Started
Figure 23: Changing the IP-Address
- 35 -
MCU-AN-391005-E-V17