Fujitsu MB91460 SERIES Початок роботи - Сторінка 35
Переглянути онлайн або завантажити pdf Початок роботи для Материнська плата Fujitsu MB91460 SERIES. Fujitsu MB91460 SERIES 41 сторінка. 32-bit microcontroller
Також для Fujitsu MB91460 SERIES: Посібник користувача (45 сторінок), Примітка до заявки (23 сторінок), Примітка до заявки (26 сторінок), Примітка до заявки (29 сторінок), Примітка до заявки (29 сторінок)
Друкувати сторінку
Chapter 7 Setup / Change Connection PC – Emulation System
•
A Fujitsu support engineer can easily help solving a concrete problem by debugging
your application out of a Fujitsu support centre.
•
You can control the emulator from different locations without having to move your
hardware installation from one place to another.
•
Program download will be more than 6 times faster than with RS232C
7.3.2 Configuring the LAN Adapter
1. Connect emulator and PC by the serial RS232-Port (or USB-Port)
3
Start the „LAN Address" Program in the Softune Workbench Folder
4
Click on Communication to define the serial RS232 Port where the emulator is
connected to or use USB connection.
5
Read current status from the emulator
6
Set the unique IP address given from your network manager. This is a very important
point; every IP-address within a network has to be unique.
7
Check the Port address: must be 5001
8
Make settings valid by „Set", and reset the emulator when prompted
9
Close Program „LAN Address"
© Fujitsu Microelectronics Europe GmbH
Getting Started
Figure 23: Changing the IP-Address
- 35 -
MCU-AN-391005-E-V17