Fujitsu SK-96320-80PMC 사용자 설명서 - 페이지 17

{카테고리_이름} Fujitsu SK-96320-80PMC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu SK-96320-80PMC 34 페이지.
Fujitsu SK-96320-80PMC에 대해서도 마찬가지입니다: 사용자 설명서 (34 페이지), 사용자 설명서 (34 페이지)

Fujitsu SK-96320-80PMC 사용자 설명서

3.7 LIN"A" (JP: 17, 18, 21, 22, 44)

One LIN-transceiver (U5, X8) can be connected to one of the microcontroller's UART
interfaces.
JP17
JP18
JP21, JP22 connects UART 7 to the LIN-transceiver (U5, X8)
JP17 (LIN enable)
JP18 (LIN Master)
JP21 (LIN"A"RXD)
JP22 (LIN"A"TXD)
JP44 (VBAT_A)
JP36 (WAKE)
By default, the LIN"A"-interface is not connected to a UART.
© Fujitsu Microelectronics Europe GmbH
Downloaded from
Elcodis.com
electronic components distributor
enable LIN-Transceiver
LIN Master-mode
If the LIN interface is not used then the jumpers should be left open.
Jumper
Setting
Closed
Open
Closed
Open
Closed
Open
Closed
Open
Closed
Open
1-2
2-3
SK-96320-80PMC User Guide
Chapter 3 Jumpers and Switches
Description
LIN-transceiver is enabled
LIN-transceiver is disabled
LIN Master-mode
LIN Slave-mode
SIN7 of the MCU is connected to LIN"A"
SIN7 of the MCU is not connected to LIN"A"
SOT7 of the MCU is connected to LIN"A"
SOT7 of the MCU is not connected to LIN"A"
Vs of LIN A is powered by the board
No voltage supply to Vs of LIN A
Connects WAKE signal to Bus power
Connects WAKE signal to VCC
- 17 -
FMEMCU-UG-960010-12