Fujitsu SK-96390-100PMC 사용자 설명서 - 페이지 20
{카테고리_이름} Fujitsu SK-96390-100PMC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu SK-96390-100PMC 32 페이지. Mb96300 series
페이지 인쇄
2.9 LIN Interface (X8, JP: 17,18,21,22,24)
One 9-pin D-Sub female connector is used
for the LIN-communication.
Jumper
JP17
(LIN A enable)
JP18
(LIN master)
JP21
(LIN A RX)
JP22
(LIN A TX)
JP44
(LIN Vbat)
2.10 CAN interface (JP: 25, 26)
One high-speed CAN-transceiver can be connected to the microcontroller's CAN interfaces
(CAN A).
Jumper
JP25
(CAN A RX)
JP26
(CAN A TX)
UG-960017-11
SK-96390-100PMC User Guide
Chapter 2 Jumpers and Switches
Connector X8:
Setting
Description
Closed
LIN A enabled
Open
LIN A disabled
Closed
LIN A is LIN Master
Open
LIN A is LIN Slave
Closed
RX2 is connected to LIN A (X8)
Closed
TX2 is connected to LIN A (X8)
Closed
LIN bus (X8 pin 1) is powered by the board
Open
LIN bus (X8 pin 1) is not powered by the board
Table 2-8: LIN A Settings
Setting
Description
Closed
RX0 is connected to CAN0 (X10)
Closed
TX0 is connected to CAN0 (X10)
Table 2-7: CAN Settings
5
9
- 20 -
© Fujitsu Microelectronics Europe GmbH
BUS +Ubat
GND
1
6