Fujitsu SK-96620_350-64PMC(1) 사용자 설명서 - 페이지 31
{카테고리_이름} Fujitsu SK-96620_350-64PMC(1)에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu SK-96620_350-64PMC(1) 47 페이지. F²mc-16lx/fx family, mb96620/350 series, mb90350 series
페이지 인쇄
5 Connectors
Pin assignment and employment of connectors
5.1 Power connector (X12)
The following figure shows the power connection jack X12. This connector is used to
connect an external unregulated DC power supply voltage (9 V - 12 V DC) to the evaluation
board.
Connector X12:
It is recommended to use 9 V to keep the power dissipation to a minimum. Otherwise, an
additional heat sink for the linear voltage regulator might be necessary.
5.2 MCU pin header connectors (X1, X2)
All pins (except oscillator and supply pins) of the microcontroller are directly connected to pin
headers.
Connector
X1 (1 – 32)
X2 (33 – 64)
On the PCB, the corresponding pin numbers of the µC are written next to the connector pins.
5.3 UART"A", UART"B" connector (X3, X5)
Two female SUB-D9 connectors are used
for the serial interface UART"A" and UART"B".
TXD is the transmit output, RXD is the receive input.
The DTR or RTS signal can be used to generate a reset.
Please use 1:1 cable for PC-connection.
© Fujitsu Semiconductor Europe GmbH
SK-96620_350-64PMC(1) User Guide
Chapter 5 Connectors
Shield is connected to ground (GND)
Centre is connected to positive voltage (+)
MCU Pins
1 – 32
33 – 64
- 31 -
GND DTR RxD TxD
5
9
CTS RTS DSR
Connectors X3, X5
UG-960028-12
1
6