Fujitsu YOKOGAWA AF221 애플리케이션 노트 - 페이지 15
{카테고리_이름} Fujitsu YOKOGAWA AF221에 대한 애플리케이션 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu YOKOGAWA AF221 24 페이지. Flash programmer - f2mc-16lx family 16-bit microcontroller all series
FLASH PROGRAMMER YOKOGAWA AF220/221
Software – Remote Controller AZ290
7 Software – Remote Controller AZ290
This chapter describes how to remote control the Yokogawa Flash-Programmer by a PC
The Remote Software Package AZ290 allows to set-up and to control the Flash-Programmer
by a PC.
Connect the Flash programmer AF220/221 via RS-232C or Ethernet to the PC. If the
Ethernet wants to be used, refer to the user-manual how to set-up the IP-address.
Start the Remote-Software AZ290. The software should automatically find the programmer.
7.1 Parameter Load
The parameter file contents the microcontroller-related information like e.g. Flash-Memory
size.
In order to load a new microcontroller series, open the tab "File Transfer" and select
"Parameter Load from HD".
After the file is successfully loaded, the MCU-type is shown on the programmers LC-display.
7.2 File transfer to PC-card
Keep in mind that the related bootloader-kernel (write control program, *.BTP) has to be
copied manually to the PC-card. This can be done by the button "File copy from HD to DOS
area" in the group "Bundle File". See chapter 5.1.1 for more details.
© Fujitsu Microelectronics Europe GmbH
- 15 -
MCU-AN-390087-E-V10