Indesit KD6G25X 사용 설명서 - 페이지 19

{카테고리_이름} Indesit KD6G25X에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit KD6G25X 24 페이지. Free standing gas cooker
Indesit KD6G25X에 대해서도 마찬가지입니다: 설치 및 사용 설명서 지침 (32 페이지), 사용 설명서 (24 페이지)

페이지 인쇄

Electrical Connection

WARNING - THIS APPLIANCE MUST BE EARTHED.

CONNECT TO A 230-240V A.C. SUPPLY ONLY.

Connection to the electricity supply should be made

via a properly earthed, readily accessible wall

socket which is adjacent to but not directly above,

and not more than 1.25m away from the appliance

and capable of electrical isolation.

The mains lead should be routed such that it cannot

touch hot parts of the cooker i.e. the back panel

above a height of 650mm from the floor.

Should this plug not fit the socket outlet in your

home it should be cut off and replaced with a

suitable plug as outlined below.

NOTE: The removed plug cannot be used for any

other appliance and should therefore be properly

disposed of and not left where children might find it

and plug it into a supply socket - with the obvious

consequent danger.

I. THE .ITTED PLUG IS REMOVED

The flexible mains lead must be correctly connected

as below to a three pin plug of not less than 13 amp

capacity. If a B.S. 1363 fused plug is used, it must

be fitted with a fuse which is approved to B.S. 1362.

IMPORTANT: The wires in the mains lead fitted to

this appliance are coloured in accordance with the

following code:

Green &

Yellow to

Earth

Brown

to Live

Blue to

3 Amp

Neutral

Fuse

Cord

Clamp

GREEN AND YELLOW

- EARTH

BLUE

- NEUTRAL

BROWN

- LIVE

As the colours of the wires in the mains lead of this

appliance may not correspond with the coloured

markings identifying the terminals in your plug,

proceed as follows:

The wire which is coloured green and yellow must be

connected to the terminal in the plug which is

marked with the letter E or by the earth symbol

or coloured green or green and yellow.

The wire which is coloured blue must be connected

to the terminal which is marked with the N or

coloured black.

The wire which is coloured brown must be connected

to the terminal which is marked with the letter L or

coloured red.

When wiring the plug, ensure that all strands of wire

are securely retained in each terminal. Do not forget

to tighten the mains lead clamp on the plug.

As the appliance must be earthed, do not use 2-pin

sockets outlets, if you are in doubt, consult a

qualified electrician.

Should the mains lead ever require replacement, it is

essential that this operation be carried out by a

qualified electrician and should only be replaced

with a flexible cord of the same size i.e. 1.0mm2

cross sectional area PVC cable, available from our

parts department (see Back Cover).

I. A MOULDED PLUG IS .ITTED

In the event of replacing a fuse in the plug supplied

an ASTA approved fuse to BS1362 must be fitted.

NOTE: The fuse cover must be refitted when

changing the fuse. In the event of losing the fuse

cover the plug must not be used until a replacement

fuse cover has been obtained and fitted. A new fuse

cover can be obtained from your local Electricity

Board. The colour of the correct replacement fuse

cover is that of the coloured marks or inserts in the

base of the plug.

Make sure that the cable does not become trapped

when pushing the cooker into position.