Indesit CRO 642 TO X RU/HA 사용 설명서 - 페이지 8

{카테고리_이름} Indesit CRO 642 TO X RU/HA에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Indesit CRO 642 TO X RU/HA 28 페이지.

페이지 인쇄

least time remaining, and the light corresponding to

the position of the hotplate will flash. The lights

corresponding to the other hotplates programmed

will be switched on.

To visualise the time remaining for the other

programmed hotplates, press the

repeatedly: the time remaining for

each hotplate will be shown

sequentially in clockwise order,

starting from the front left hotplate.

Changing the programme

1. Press the

you wish to change is shown.

2. Use the

buttons to set the new duration.

3. Confirm by pressing the

To cancel a programme, follow the above

instructions. At step 2, press the

duration decreases progressively until it reaches 0

and switches off. The programme resets and the

display exits programming mode.

Timer

The hob must be switched on.

The timer can be used to set a duration up to 99

minutes.

1. Press the

indicator light is illuminated

2. Set the desired duration using the

buttons.

3. Confirm by pressing the

The timer begins counting down immediately. When

the time has elapsed, a buzzer will sound (for one

minute).

Control panel lock

When the hob is switched on, it is possible to lock

the oven controls in order to avoid accidental

changes being made to the settings (by children,

during cleaning, etc.). Press the

the control panel: the indicator light above the button

will switch on.

button

button repeatedly until the duration

button.

- - - - -

button: the

programming button until the timer

- - - - -

and

button.

button to lock

To use any of the controls (e.g. to stop cooking),

you must switch off this function. Press the

button for a few moments, the indicator light will

switch off and the lock function will be removed.

Switching off the hob

Press the

If the control panel lock has been activated, the

controls will continue to be locked even after the hob

is switched on again. In order to switch the hob on

again, you must first remove the lock function.

"Demo" mode

It is possible to set the hob to a demonstration

mode where all the controls work normally but the

heating elements do not switch on. To activate the

"demo" mode the hob must be switched on, with all

the hotplates switched off.

• Press and hold the

simultaneously for 6 seconds. When the 6

seconds have elapsed, the ON/OFF and

CONTROLS LOCKED indicator lights will flash for

one second. Release the

press the

• The display will show the text DE and MO and the

hob will be switched off.

• When the hob is switched on again it will be set to

the "demo" mode.

To exit this mode, follow the procedure described

above. The display will show the text DE and OF

+ + + + +

and the hob will be switched off. When it is next

switched on, the hob will function normally.

Practical advice on using the appliance

To obtain the best results from your hob:

• Use pans with a thick, flat base in order to fully

utilise the cooking zone.

• Always use pans with a diameter which is large

enough to cover the hotplate fully, in order to use all

the available heat.

button to switch the appliance off.

+ + + + +

- - - - -

and

buttons

+ + + + +

- - - - -

and

buttons and

button;