Indesit CRO 642 TO X RU/HA Інструкція з експлуатації Посібник з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Варильна поверхня Indesit CRO 642 TO X RU/HA. Indesit CRO 642 TO X RU/HA 28 сторінок.
Друкувати сторінку
least time remaining, and the light corresponding to
GB
the position of the hotplate will flash. The lights
corresponding to the other hotplates programmed
will be switched on.
To visualise the time remaining for the other
programmed hotplates, press the
repeatedly: the time remaining for
each hotplate will be shown
sequentially in clockwise order,
starting from the front left hotplate.
Changing the programme
1. Press the
you wish to change is shown.
2. Use the
buttons to set the new duration.
3. Confirm by pressing the
To cancel a programme, follow the above
instructions. At step 2, press the
duration decreases progressively until it reaches 0
and switches off. The programme resets and the
display exits programming mode.
Timer
The hob must be switched on.
The timer can be used to set a duration up to 99
minutes.
1. Press the
indicator light is illuminated
2. Set the desired duration using the
buttons.
3. Confirm by pressing the
The timer begins counting down immediately. When
the time has elapsed, a buzzer will sound (for one
minute).
Control panel lock
When the hob is switched on, it is possible to lock
the oven controls in order to avoid accidental
changes being made to the settings (by children,
during cleaning, etc.). Press the
the control panel: the indicator light above the button
will switch on.
8
button
button repeatedly until the duration
button.
- - - - -
button: the
programming button until the timer
.
- - - - -
and
button.
button to lock
To use any of the controls (e.g. to stop cooking),
you must switch off this function. Press the
button for a few moments, the indicator light will
switch off and the lock function will be removed.
Switching off the hob
Press the
If the control panel lock has been activated, the
controls will continue to be locked even after the hob
is switched on again. In order to switch the hob on
again, you must first remove the lock function.
"Demo" mode
It is possible to set the hob to a demonstration
mode where all the controls work normally but the
heating elements do not switch on. To activate the
"demo" mode the hob must be switched on, with all
the hotplates switched off.
• Press and hold the
simultaneously for 6 seconds. When the 6
seconds have elapsed, the ON/OFF and
CONTROLS LOCKED indicator lights will flash for
one second. Release the
press the
• The display will show the text DE and MO and the
hob will be switched off.
• When the hob is switched on again it will be set to
the "demo" mode.
To exit this mode, follow the procedure described
above. The display will show the text DE and OF
+ + + + +
and the hob will be switched off. When it is next
switched on, the hob will function normally.
Practical advice on using the appliance
To obtain the best results from your hob:
• Use pans with a thick, flat base in order to fully
utilise the cooking zone.
• Always use pans with a diameter which is large
enough to cover the hotplate fully, in order to use all
the available heat.
button to switch the appliance off.
+ + + + +
- - - - -
and
buttons
+ + + + +
- - - - -
and
buttons and
button;