AEG 7000 Series 사용자 설명서 - 페이지 41
{카테고리_이름} AEG 7000 Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 7000 Series 49 페이지.
AEG 7000 Series에 대해서도 마찬가지입니다: 사용자 설명서 (32 페이지), 사용자 설명서 (44 페이지), 사용자 설명서 (32 페이지), 사용자 설명서 (28 페이지), 사용자 설명서 (36 페이지)
페이지 인쇄
13.12 Frost precautions
If the appliance is installed in an area
where the temperature can reach values
around 0° C or drop below, remove the
remaining water from the inlet hose and
the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in
a container and let the water flow out
of the hose.
14. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
14.1 Alarm Codes and Possible failures
The appliance does not start or it stops during operation. First try to find a solution to the
problem (refer to the tables).
WARNING!
Deactivate the appliance before carrying out any check.
With some problems, the display shows an alarm code and the Start/Pause button may
flash continuously:
If the appliance is overloaded, remove some items from the drum and/or
keep pressed the door while touching the Start/Pause button until the
indicator
Problem
stops flashing (see the picture below).
Possible solution
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty,
install the inlet hose again.
WARNING!
Make sure that the
temperature is higher than
0 °C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
ENGLISH
41