2N Lift8 간단한 매뉴얼 - 페이지 7
{카테고리_이름} 2N Lift8에 대한 간단한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 2N Lift8 12 페이지. Io module
2N Lift8에 대해서도 마찬가지입니다: 간단한 매뉴얼 (8 페이지), 간단한 매뉴얼 (13 페이지), 간단한 매뉴얼 (14 페이지), 간단한 매뉴얼 (6 페이지), 간단한 매뉴얼 (12 페이지), 간단한 매뉴얼 (17 페이지)
Error during programming
If you make an error when entering the number (either for the number of the
function or the value), and you realise this before you press the asterisk, you can
cancel the entire number by pressing the
If L8 rejects the selected number of the parameter or specified value, it is
possible to continue programming – the number of the function must be entered
again even if only the value was incorrect.
If you program a value other than the one you wanted, and the value is saved,
you can naturally enter the correct number again.
End of programming
If you call the L8 via a telephone number. End programming by hanging up.
If you are programming via the machine room audio unit, by pressing
than 2 seconds) you end programming and put the audio unit on standby.
If you only want to go back one menu, press
Cooperating 2N
®
2N
Service tool
The application is intended for remote supervision and configuration of 2N
communicators.
®
2N
Control panel
The application is intended for the administration of users, lifts and authorisations.
®
2N
Communicator
The application is intended for the receipt of emergency calls by a dispatcher.
®
2N
Server
The application processes the control calls and mediates communication between the
central units and PC applications.
®
applications
symbol and enter it again.
.
(longer
®
Lift8
6