AEG A81000TNW0 사용자 설명서 - 페이지 15

{카테고리_이름} AEG A81000TNW0에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG A81000TNW0 20 페이지. Built in freezer
AEG A81000TNW0에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지), 사용자 설명서 (36 페이지)

페이지 인쇄
AEG A81000TNW0 사용자 설명서
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc. Ensure that air can circulate freely
around the back of the cabinet.To ensure best
performance, if the appliance is positioned below
an overhanging wall unit, the minimum distance
between the top of the cabinet and the wall unit
must be at least 100 mm . Ideally, however, the
appliance should not be positioned below over-
hanging wall units. Accurate levelling is ensured
by one or more adjustable feet at the base of the
cabinet. If the cabinet is placed in a corner and
the side with the hinges facing the wall, the dis-
tance between the wall and the cabinet must be at least 10 mm to allow the door to open
enough so that the shelves can be removed.
WARNING!
It must be possible to disconnect the appliance from the mains power supply; the plug
must therefore be easily accessible after installation.

Door reversibility

To carry out the following operations, we suggest that this be made with another person
that will keep a firm hold on the doors of the appliance during the operations.
To change the opening direction of the door, do these steps:
1.
Remove the plug from the power socket.
2.
Tilt back the appliance carefully so that the compressor cannot touch the floor.
3.
Unscrew both adjustable feet.
4.
Unscrew the screws of the door bottom
hinge.
5.
Take off the appliance door by pulling it
slightly downwards.
15
Installation