A-Neuvideo HD-44G 사용 설명서 - 페이지 5
{카테고리_이름} A-Neuvideo HD-44G에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. A-Neuvideo HD-44G 20 페이지. Ethernet (tcp) set up
A-Neuvideo HD-44G에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지), 사용 설명서 (6 페이지)
페이지 인쇄
A
NEUVIDEO
FRONT PANEL
POWER SWITCH:
The power switch turns the unit on and off. The LED will illuminate red to indicate that the switcher is ON and
q
is receiving power. The Switcher will remember that last state during a power cycle. When power is removed and resorted, the last
configuration will be evoked.
INPUT SELECT BUTTONS:
w
OUTPUT STATUS DISPLAY:
e
r
DESTINATION SELECT BUTTONS:
Routing can be Source to Destination or one source to multiple destinations. Example : Press Destination 1,2,4 then press Source 2 will
route Input 2 to Output 1,2,4 respectfully.
EDID MODE SELECT BUTTONS:
t
y
IR SENSOR:
The IR sensor receives IR commands from the supplied remote controller or third party IR emitter.
SOURCE SELECT BUTTONS:
u
FUNCTION KEY - ALL
i
Input sources (1) to (4) LCM illuminates blue to indicate that a video source is present on that input.
Each Output (destination) Channel shows which input (source) is assigned.
Separate outputs (1) thru (4) select buttons are provided for each destination assignment.
Used to select EDID mode using Input buttons #1 and #2.
Separate inputs (1) thru (4) select buttons are provided each source selection.
Disables (mute) video on all destinations OR Selects the same source to all destinations.
Option 1
- Press ALL followed by OFF button. The display will show " 0 " indicating all destinations
have no video selected.
Option 2
- Press ALL followed by Source 1 thru 4. The display will show the Source selected.
- Press ENTER The pre-set source selection will be assigned all destinations.
3
FRONT PANEL