AEG OKO SANTO 290-6i 작동 및 설치 지침 - 페이지 13

{카테고리_이름} AEG OKO SANTO 290-6i에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG OKO SANTO 290-6i 25 페이지. Integrating fridge-freezer

If the appliance is fixed to the

side of the kitchen unit, simply

slacken the screws in the fixing

brackets (D), move the brack-

ets as shown in the figure and

re-tighten the screws. Fit cover

(E).

Prior to Initial StartÐUp

¥ Please clean the appliance interior and all accessories prior to ini-

tial start-up (see section: ÒCleaning and CareÓ).

Any electrical work required to install this appliance should be carried

out by a qualified electrician or competent person.

WARNING Ð THIS APPLIANCE MUST BE EARTHED

The manufacturer declines any liability should these safety

measures not be observed.

Before switching on, make sure the electricity supply voltage is the

same as that indicated on the appliance rating plate. The rating pla-

te is inside, on the left.

The appliance is supplied with a 13 amp plug fitted. In the event of

having to change the fuse in the plug supplied, a 13 amp ASTA

approved (BS 1362) fuse must be used.

Important!

The wires in the mains lead are coloured in accordance with the fol-

lowing code:

Green and Yellow Earth

Blue Neutral

Brown Live

As the colours of the wires in the mains lead of this appliance may

not correspond with the coloured markings indentifying the terminals

in your plug, proceed as follows:

D734