AEG SCT71906S0 사용자 설명서 - 페이지 16
{카테고리_이름} AEG SCT71906S0에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG SCT71906S0 24 페이지.
페이지 인쇄16
www.aeg.com
9.3 Ventilation requirements
The airflow behind the appliance must
be sufficient.
5 cm
CAUTION!
Refer to the assembly
instructions for the
installation.
9.4 Door reversibility
1. Loosen and remove the upper pin
and the spacer.
2. Remove the upper door.
3. Unscrew the pins (B) and spacers (C).
4. Remove the door.
5. Remove the lower spacer.
6. Loosen the lower pin with a key.
min.
2
200 cm
min.
200 cm
2
C
B
C
7. Tighten the lower pin on the
opposite side.
8. Install the lower spacer.
9. Install the door.
10. Refit the pins (B) and the spacers (C)
on the middle hinge on the opposite
side.
11. Tighten the spacer and the upper
pin.
Do a final check to make
sure that:
• All screws are tightened.
• The magnetic seal
adheres to the cabinet.
• The door opens and
closes correctly.
If the ambient temperature
is cold (i.e. in Winter), the
gasket may not fit perfectly
to the cabinet. In that case,
wait for the natural fitting of
the gasket.
In case you do not want to
carry out the above
mentioned operations,
contact the nearest
Authorised Service Centre.
The Authorised Service
specialist will carry out the
reversibility of the doors at
your cost.
9.5 Installing the appliance
CAUTION!
Make sure that the mains
cable can move freely.
1. If necessary cut the adhesive sealing
strip and then apply it to the
appliance as shown in figure.