AEG 2060 D 운영 및 설치 매뉴얼 - 페이지 9

{카테고리_이름} AEG 2060 D에 대한 운영 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 2060 D 19 페이지. Electrolux cooker hood operating and installation instructions 2060 d
AEG 2060 D에 대해서도 마찬가지입니다: 작동 및 설치 지침 (20 페이지), 운영 및 설치 매뉴얼 (19 페이지)

페이지 인쇄

Carbon filter

• The carbon filter should only be used if you want to use the hood in

its filtering function.

• To do this you will need an original AEG activated carbon filter (see

special accessories).

• Cleaning/replacing the carbon filter

Unlike other carbon filters, the LONGLIFE carbon filter can be

cleaned and reactivated. At normal use the filter should be cleaned

every second month. The best way to clean the filter is in the

dishwasher. Use normal detergent and choose the highest tempera-

ture (65º C). Wash the filter separately so that no food parts gets

stuck on the filter and later causes bad odours. To reactivate the

carbon, the filter should be dried in an oven for 10 minutes with a

temperature of maximum 100º C.

After approximately three years of use, the carbon filter should be

replaced with a new, as the odour reduction capacity will be

reduced.

• Mounting

Fit the carbon filter first rearward on the long supporting tongue,

then rotate it to close the motor housing and fix it using its two red

keys A. Fig. 4.

• To dismount proceed in reverse order.

• Always specify the hood model code number and serial number

when ordering replacement filters. This information is shown on the

registration plate located on the inside of the unit.

• The activated carbon filter can be ordered from the AEG technical

assistance service.

Fig. 4