AEG 2060 D Посібник з експлуатації та встановлення - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник з експлуатації та встановлення для Вентиляційна витяжка AEG 2060 D. AEG 2060 D 19 сторінок. Electrolux cooker hood operating and installation instructions 2060 d
Також для AEG 2060 D: Інструкція з експлуатації та монтажу (20 сторінок), Посібник з експлуатації та встановлення (19 сторінок)

Carbon filter

• The carbon filter should only be used if you want to use the hood in

its filtering function.

• To do this you will need an original AEG activated carbon filter (see

special accessories).

• Cleaning/replacing the carbon filter

Unlike other carbon filters, the LONGLIFE carbon filter can be

cleaned and reactivated. At normal use the filter should be cleaned

every second month. The best way to clean the filter is in the

dishwasher. Use normal detergent and choose the highest tempera-

ture (65º C). Wash the filter separately so that no food parts gets

stuck on the filter and later causes bad odours. To reactivate the

carbon, the filter should be dried in an oven for 10 minutes with a

temperature of maximum 100º C.

After approximately three years of use, the carbon filter should be

replaced with a new, as the odour reduction capacity will be

reduced.

• Mounting

Fit the carbon filter first rearward on the long supporting tongue,

then rotate it to close the motor housing and fix it using its two red

keys A. Fig. 4.

• To dismount proceed in reverse order.

• Always specify the hood model code number and serial number

when ordering replacement filters. This information is shown on the

registration plate located on the inside of the unit.

• The activated carbon filter can be ordered from the AEG technical

assistance service.

Fig. 4