AEG 222 D 설치 및 운영 지침 매뉴얼 - 페이지 16

{카테고리_이름} AEG 222 D에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 222 D 20 페이지. Fume extractor hood
AEG 222 D에 대해서도 마찬가지입니다: 설치 및 운영 지침 매뉴얼 (20 페이지), 설치 및 운영 지침 매뉴얼 (20 페이지), 설치 및 운영 지침 매뉴얼 (20 페이지), 설치 및 운영 지침 매뉴얼 (20 페이지)

AEG 222 D 설치 및 운영 지침 매뉴얼
Warning
• Failure to observe the instructions on cleaning the unit and
changing the filters will cause a fire hazard. You are therefore
strongly recommended to follow these instructions.
Changing the light bulb
• Disconnect the unit from the mains power supply.
• Remove the grid.
• Replace the old light bulb with a new light bulb (40 W
max.).
• If the light does not come on, make sure the bulb has
been screwed in correctly before contacting the technical
assistance service.
Cleaning
• Warning: always disconnect the hood from the mains power
supply before cleaning it.
Never insert pointed objects in the motor's protective grid.
• Wash the outside surfaces using a delicate detergent solution.
Never use caustic detergents or abrasive brushes or powders.
• Only ever clean the switch panel and filter grille using a damp
cloth and delicate detergents.
• It is extremely important to clean the unit and change the filters
at the recommended intervals. Failure to do so will cause grease
deposits to build up that could constitute a fire hazard.
Accessories
The following accessoires can be ordered through your retailers.
MKZ telescopic wall pipe outlet hose ABS120,120 mm 0
Synthetic grease filter
Metal grease filter MFF2
Carbon filter KFF
16