AEG 2600 D 작동 및 설치 지침 - 페이지 15

{카테고리_이름} AEG 2600 D에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 2600 D 20 페이지.
AEG 2600 D에 대해서도 마찬가지입니다: 운영 및 설치 매뉴얼 (16 페이지)

Mounting – Figure 8

• Position the template (1) on the wall and mark the position, and drill

the holes (2 x Ø 8 mm).Mount the two rawl plugs with the hooks (3)

• Hang the hood on the hooks and level it with the adjustment screws

(4)

• Remove the grease filters (5) and mark for the two screws (6).

Remove the hood and drill the holes (2 x Ø 8 mm).

• Insert the rawl plugs (7) and hang the hood on the wall again. Adjust

it horizontally with the screws (8) and secure it with the screws (9)

• Mount the wall bracket (10) with the wall plugs (9a) and the screws

(11).

Be careful that it is centered over the hood and horizontally aligned.

Fitting for extractor version (S)

Connect a tube between the hood air outlet and the wall or roof exhaust

channel. Fix it with the tube clamps supplied.

Fitting for filter version

Mount the deflector (12) with the two screws (13) supplied.

Mounting the chimney

• Place the chimney and fix it to the top wall bracket with the two

screws (16) supplied.

• Lower the bottom part of the chimney and fasten it to the top of the

hood with two screws (17), supplied.

Note that the top part of the chimney can be mounted with the side

grids up or down. For use as a filter version hood it must be mounted

with the grids upwards. Fig. 7.

Fig. 7