AEG 2600 D Çalıştırma ve Kurulum Talimatları - Sayfa 15
Havalandırma Davlumbazı AEG 2600 D için çevrimiçi göz atın veya pdf Çalıştırma ve Kurulum Talimatları indirin. AEG 2600 D 20 sayfaları.
Ayrıca AEG 2600 D için: Kullanım ve Kurulum Kılavuzu (16 sayfalar)
Sayfayı Yazdır
Mounting – Figure 8
• Position the template (1) on the wall and mark the position, and drill
the holes (2 x Ø 8 mm).Mount the two rawl plugs with the hooks (3)
• Hang the hood on the hooks and level it with the adjustment screws
(4)
• Remove the grease filters (5) and mark for the two screws (6).
Remove the hood and drill the holes (2 x Ø 8 mm).
• Insert the rawl plugs (7) and hang the hood on the wall again. Adjust
it horizontally with the screws (8) and secure it with the screws (9)
• Mount the wall bracket (10) with the wall plugs (9a) and the screws
(11).
Be careful that it is centered over the hood and horizontally aligned.
Fitting for extractor version (S)
Connect a tube between the hood air outlet and the wall or roof exhaust
channel. Fix it with the tube clamps supplied.
Fitting for filter version
Mount the deflector (12) with the two screws (13) supplied.
Mounting the chimney
• Place the chimney and fix it to the top wall bracket with the two
screws (16) supplied.
• Lower the bottom part of the chimney and fasten it to the top of the
hood with two screws (17), supplied.
Note that the top part of the chimney can be mounted with the side
grids up or down. For use as a filter version hood it must be mounted
with the grids upwards. Fig. 7.
Fig. 7
15