AEG HD 8795 작동 및 설치 지침 - 페이지 7
{카테고리_이름} AEG HD 8795에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG HD 8795 20 페이지. Cooker hood
AEG HD 8795에 대해서도 마찬가지입니다: 작동 및 설치 지침 (20 페이지), 작동 및 설치 지침 (20 페이지)
페이지 인쇄
Switching on the hood - Fig. 3
The control ball is a balancer switch.
Depressing the control ball repeatedly towards
the bottom, switches on the hood and you may
select the motor level desired, depressing once
again the hood switches off.
Switching on the light - Fig. 3
Depress the control ball towards the top :
once for reduced lighting,
once again for full lighting,
depress again to switch off the light.
Indicator light for grease or
charcoal filter
The air duct, in this hood, includes a device
that signals when the filter requires cleaning or
changing .
Led signal for grease filter
The LED signal flickers (flickering green light) when the grease filter
requires cleaning, occurs at about 40 operating hours.
Ensure that the indicator light is checked each time the hood is used.
Led signal for charcoal filter
The LED signal flickers (flickering orange light) when the charcoal filter
requires cleaning, occurs at about 160 operating hours.
Ensure that the indicator light is checked each time the hood is used.
Re-setting the saturation signal
After cleaning or replacing the filter, select the intensive speed (the
control ball lights up with a red flashing light), depress again and hold
depressed for about 3 seconds until an audible signal indicates the
reset has taken place.
depress towards the
bottom to switch on
the hood.
depress towards
the top to switch
on the lights
Fig. 3
7