AEG HD 8795 Instructions d'utilisation et d'installation - Page 7
Parcourez en ligne ou téléchargez le pdf Instructions d'utilisation et d'installation pour {nom_de_la_catégorie} AEG HD 8795. AEG HD 8795 20 pages. Cooker hood
Également pour AEG HD 8795 : Instructions d'utilisation et d'installation (20 pages), Instructions d'utilisation et d'installation (20 pages)
Imprimer la page
Switching on the hood - Fig. 3
The control ball is a balancer switch.
Depressing the control ball repeatedly towards
the bottom, switches on the hood and you may
select the motor level desired, depressing once
again the hood switches off.
Switching on the light - Fig. 3
Depress the control ball towards the top :
once for reduced lighting,
once again for full lighting,
depress again to switch off the light.
Indicator light for grease or
charcoal filter
The air duct, in this hood, includes a device
that signals when the filter requires cleaning or
changing .
Led signal for grease filter
The LED signal flickers (flickering green light) when the grease filter
requires cleaning, occurs at about 40 operating hours.
Ensure that the indicator light is checked each time the hood is used.
Led signal for charcoal filter
The LED signal flickers (flickering orange light) when the charcoal filter
requires cleaning, occurs at about 160 operating hours.
Ensure that the indicator light is checked each time the hood is used.
Re-setting the saturation signal
After cleaning or replacing the filter, select the intensive speed (the
control ball lights up with a red flashing light), depress again and hold
depressed for about 3 seconds until an audible signal indicates the
reset has taken place.
depress towards the
bottom to switch on
the hood.
depress towards
the top to switch
on the lights
Fig. 3
7