AEG HD 8990 작동 및 설치 지침 - 페이지 16
{카테고리_이름} AEG HD 8990에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG HD 8990 20 페이지. Electrolux group. operating and installation instructions cooker hood hd 8990, hd 8960
AEG HD 8990에 대해서도 마찬가지입니다: 작동 및 설치 지침 (20 페이지), 작동 및 설치 지침 (20 페이지), 작동 및 설치 지침 (20 페이지), 작동 및 설치 지침 (20 페이지)
페이지 인쇄
Wall unit mounting - Fig. 7-8
Assembling the chimney flue support/
bracket:
The three parts should be fixed with 4
screws, the support extension is
adjustable and should correspond to the
internal width of the telescopic chimney
flue. Fig. 7.
Mark the wall with a centre line, this will
aid mounting procedure (1), position the
template so that the mid line printed on
the template matches with the centre line
previously drawn, the lower side of the
template corresponds to the lower side of
the hood once mounted (2).
Drill two holes Ø 8mm and fix the support
bracket with two wall plugs and screws
(3). The wall plugs, if supplied, are for
brick or solid block fixings only, excluding
thermal blocks and similar. For mounting
on any surface other than brick, the correct fixings must be used.
Hang the hood (4) and adjust its position (5-6).
From the inside of the hood mark two points for definitive fixing (7).
Remove the hood (8) and drill two holes Ø 8mm (9), fit two wall
plugs (10).
Drill two holes Ø 8mm on the upper side close to the ceilling, fit two
wall plugs (11) (In case the hood is to be used in recirculation
mode, mount the deflector F on the chimney support with 2 screws
2,9x6,5 and fix the chimney support G with two screws (12).
Hang the hood again (13) and fix it definitively with two screws (14).
Fit an exhausting pipe (15) to connect the outlet hole A of the hood
to the outside (Extractor hood) or to the deflector F (recirculation
mode).
Make electrical connection (16).
Fix the chimney first up (17a) to the chimney support (17b), then
slide the lower section of the chimney down into the proper housing
on top of the hood (18).
16
All manuals and user guides at all-guides.com
G
=
=
X
X
H
Fig. 7