AEG HD 8990 Instruções de utilização e de instalação - Página 16

Procurar online ou descarregar pdf Instruções de utilização e de instalação para Campânula de ventilação AEG HD 8990. AEG HD 8990 20 páginas. Electrolux group. operating and installation instructions cooker hood hd 8990, hd 8960
Também para AEG HD 8990: Instruções de utilização e de instalação (20 páginas), Instruções de utilização e de instalação (20 páginas), Instruções de utilização e de instalação (20 páginas), Instruções de utilização e de instalação (20 páginas)

Wall unit mounting - Fig. 7-8

Assembling the chimney flue support/

bracket:

The three parts should be fixed with 4

screws, the support extension is

adjustable and should correspond to the

internal width of the telescopic chimney

flue. Fig. 7.

Mark the wall with a centre line, this will

aid mounting procedure (1), position the

template so that the mid line printed on

the template matches with the centre line

previously drawn, the lower side of the

template corresponds to the lower side of

the hood once mounted (2).

Drill two holes Ø 8mm and fix the support

bracket with two wall plugs and screws

(3). The wall plugs, if supplied, are for

brick or solid block fixings only, excluding

thermal blocks and similar. For mounting

on any surface other than brick, the correct fixings must be used.

Hang the hood (4) and adjust its position (5-6).

From the inside of the hood mark two points for definitive fixing (7).

Remove the hood (8) and drill two holes Ø 8mm (9), fit two wall

plugs (10).

Drill two holes Ø 8mm on the upper side close to the ceilling, fit two

wall plugs (11) (In case the hood is to be used in recirculation

mode, mount the deflector F on the chimney support with 2 screws

2,9x6,5 and fix the chimney support G with two screws (12).

Hang the hood again (13) and fix it definitively with two screws (14).

Fit an exhausting pipe (15) to connect the outlet hole A of the hood

to the outside (Extractor hood) or to the deflector F (recirculation

mode).

Make electrical connection (16).

Fix the chimney first up (17a) to the chimney support (17b), then

slide the lower section of the chimney down into the proper housing

on top of the hood (18).

All manuals and user guides at all-guides.com

Fig. 7