AEG protect d. 3000 운영 및 설치 매뉴얼 - 페이지 15

{카테고리_이름} AEG protect d. 3000에 대한 운영 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG protect d. 3000 19 페이지. Aeg cooktop user manual
AEG protect d. 3000에 대해서도 마찬가지입니다: 작동 및 설치 지침 (17 페이지)

페이지 인쇄

Wall unit mounting - Fig. 8

• Insert the frame, that holds controls, grease filter and lamps, in the

motor housing using proper rails and fix each other with two 3x9

screws (1-2-3).

• Sign the wall with a center line, this will aid mounting procedure (4),

position the template so that the mid line printed on the template

matches with the center line previously signed, the lower side of the

template corresponds to the lower side of the hood once mounted

(5).

• Drill two holes Ø 8mm and fix the support bracket with two wall plugs

and screws (6).

• Hang the hood (7) adjust its position (8-9) and from the inside of the

hood sign one point for definitive fixing (10), remove the hood and drill

an hole Ø 8mm (11), fit a wall plugs, hang the hood again and fix it

definitively with a screw (12).

• Drill two holes Ø 8mm on the upper side close to the ceilling (13), fit

two wall plugs and fix the chimney support with two screws (14).

In case the hood is to be used in filter version, mount the deflector

F on the chimney support with four screws 2,9x6,5 and fit an

exhausting pipe (15) to connect deflector to the outlet hole D of the

hood.

In case the hood is to be used in exhausting version, then the

deflector must not be mounted and fit an exhausting pipe (15) to

connect outlet hole D of the hood to the outside.

• Make electrical connection (16), but leave the hood disconnected

from the home general electric panel.

• Connect lamps and control panel to the motor housing (17).

• Insert the vapour screen on the motor housing and fix it with four

screws M4x35 (18).

Model 3010D has an additional part that can be mounted to the first

part fixed on step 18 before or after this step, choose the

convenience, fixing between this two parts must be done with four

screws.

• Fix the chimney first up (19a) to the chimney support (19b), then on

the bottom (20a) to the upper side of the frame (20b) using four

screws 2,9x6,5.

• Connect the hood the the home general electric panel and check if

the hood work properly.