AEG protect d. 3000 Manual de operação e instalação - Página 15
Procurar online ou descarregar pdf Manual de operação e instalação para Campânula de ventilação AEG protect d. 3000. AEG protect d. 3000 19 páginas. Aeg cooktop user manual
Também para AEG protect d. 3000: Instruções de utilização e de instalação (17 páginas)
Imprimir página
Wall unit mounting - Fig. 8
• Insert the frame, that holds controls, grease filter and lamps, in the
motor housing using proper rails and fix each other with two 3x9
screws (1-2-3).
• Sign the wall with a center line, this will aid mounting procedure (4),
position the template so that the mid line printed on the template
matches with the center line previously signed, the lower side of the
template corresponds to the lower side of the hood once mounted
(5).
• Drill two holes Ø 8mm and fix the support bracket with two wall plugs
and screws (6).
• Hang the hood (7) adjust its position (8-9) and from the inside of the
hood sign one point for definitive fixing (10), remove the hood and drill
an hole Ø 8mm (11), fit a wall plugs, hang the hood again and fix it
definitively with a screw (12).
• Drill two holes Ø 8mm on the upper side close to the ceilling (13), fit
two wall plugs and fix the chimney support with two screws (14).
In case the hood is to be used in filter version, mount the deflector
F on the chimney support with four screws 2,9x6,5 and fit an
exhausting pipe (15) to connect deflector to the outlet hole D of the
hood.
In case the hood is to be used in exhausting version, then the
deflector must not be mounted and fit an exhausting pipe (15) to
connect outlet hole D of the hood to the outside.
• Make electrical connection (16), but leave the hood disconnected
from the home general electric panel.
• Connect lamps and control panel to the motor housing (17).
• Insert the vapour screen on the motor housing and fix it with four
screws M4x35 (18).
Model 3010D has an additional part that can be mounted to the first
part fixed on step 18 before or after this step, choose the
convenience, fixing between this two parts must be done with four
screws.
• Fix the chimney first up (19a) to the chimney support (19b), then on
the bottom (20a) to the upper side of the frame (20b) using four
screws 2,9x6,5.
• Connect the hood the the home general electric panel and check if
the hood work properly.
76