Kohler BodySpa K-1000 설치 지침 매뉴얼 - 페이지 24
{카테고리_이름} Kohler BodySpa K-1000에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler BodySpa K-1000 28 페이지. Tower custom hydro-massage system
Kohler BodySpa K-1000에 대해서도 마찬가지입니다: 주택 소유자 매뉴얼 (48 페이지)
페이지 인쇄
16. CONFIRM PROPER OPERATION
A. START-UP BODYSPA
Please perform the following so the owner can safely
receive the benefits of their BodySpa.
Water temperature in the footbath should not exceed
104_F (40_C).
1.
Fill the footbath to the bottom of the drain overflow.
TE:
NO
Refer to the chart at right for the proper operating
sequence.
2.
Turn on the BodySpa by pressing the Power button
on the keypad. Water will flow from the Waterfall at
the lowest flow setting, and the Waterfall light will turn
on. The light will remain on throughout the operating
sequence.
3.
Use the
and
arrows to vary the water force.
4.
Press the Body Jet button. Water will flow from Body
Jet arrays 2, 3, and 4 at low speed. Water will stop
flowing from the Waterfall.
5.
This BodySpa features five pairs of Body Jets. Press
any combination of buttons 1 through 5 to choose the
desired water distribution.
6.
Use the
and
arrows to vary the water force.
7.
A built-in timer automatically stops the motor after 20
minutes of operation.
AB
116290-2-
TO
Turn on the
BodySpa.
Select desired
BodySpa
features.
Increase water
force, press the
button.
Decrease water
force, press the
button.
Shut off the
BodySpa.
Restart
BodySpa
after the
20 minute
cycle is
complete.
24
METHOD
OBSERVE
Kohler Co., Kohler WI U.S.A.