Kohler Chablis K-2083-1 설치 매뉴얼 - 페이지 4

{카테고리_이름} Kohler Chablis K-2083-1에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler Chablis K-2083-1 20 페이지. Pedestal lavatory

Preparation (cont.)

NOTE: The supply stop handles can not extend more than 4-3/4"

(12.1 cm) from the ﬁnished wall when in the fully open position.

Install the water supplies and drain piping according to the

roughing-in information. Install the supply stops so the handles

will not touch the pedestal when fully open.

Install sufficient backing behind the ﬁnished wall to provide a

secure material for the anchoring devices.

NOTE: Ensure that the hanger is level and is secured to the backing

material behind the ﬁnished wall.

NOTE: Ensure that the spring clips are between the hanger and the

ﬁnished wall before tightening.

Using 1/4" (6 mm) lag bolts or equivalent (not provided), install

the hanger, spring clips, and angle bracket to the wall according

to the roughing-in information.

Carefully lift the lavatory into place on the hanger, and level. You

may need to raise or lower the hanger so the lavatory contacts

the wall evenly.

NOTE: The lavatory must be supported by the hanger.

Locate the two lavatory anchoring holes, and mark the hole

locations on the ﬁnished wall.

Carefully remove the lavatory from the area.

1010431-2-B

Kohler Co.