Kohler Chablis K-2083-1 설치 매뉴얼 - 페이지 5

{카테고리_이름} Kohler Chablis K-2083-1에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler Chablis K-2083-1 20 페이지. Pedestal lavatory

Hanger

Spring Clips

Angle Bracket

Lavatory

Level

Anchoring

Holes

2. Install the Lavatory

Drill two 1/4" (6 mm) mounting holes at the marked locations on

the ﬁnished wall.

NOTE: Do not fully tighten the slip-joint drain connections at this

time.

Install the faucet and drain to the lavatory according to the

manufacturer's instructions.

CAUTION: Risk of product damage. Do not overtighten the lag

bolts. Overtightening may damage the product.

Carefully set the lavatory on the hanger. Level the lavatory, and

carefully secure the lavatory to the wall with lag bolts and

washers. Tighten until snug.

Connect and tighten the trap to the drain. Complete the water

supply connections to the faucet according to the instructions

packed with the faucet.

Apply the six self-adhesive gaskets to the top edge of the shroud.

Place the shroud next to the wall and lift so that the ﬂanges slide

under the spring clips. Adjust as needed for the proper ﬁt.

CAUTION: Risk of product damage. Do not overtighten the

mounting bolts. Overtightening may damage the product.

Insert the mounting bolts with washers through the holes in the

bottom side of the shroud until they contact the angle bracket.

Carefully tighten the mounting bolts.

Complete and test the connection of the drain and supply piping.

Kohler Co.

Gasket

Top of Shroud

Washer

Lag Bolt

1010431-2-B