AEG ADS854R5SB 사용자 설명서 - 페이지 23
{카테고리_이름} AEG ADS854R5SB에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG ADS854R5SB 32 페이지.
페이지 인쇄
9. TROUBLESHOOTING
9.1 Troubleshooting
Problem
You cannot activate the
appliance.
The program does not start.
The appliance door does not
close.
The appliance stops during
operation.
The cycle time is too long or
unsatisfactory drying result.
The display shows "
The display shows Error code.
Isolated wet spots on fabrics
after "Vapour Refresh" cycle
completed.
Possible solution
Make sure that the mains plug is connected to
the mains socket.
Check fuse in fuse box (domestic installation).
Press Start/Pause.
Make sure that the appliance door is closed.
Make sure that the installation of the filter is
correct.
Make sure that the laundry is not caught
between the appliance door and the rubber seal.
Load is too small, increase the load or use the
Time Drying program.
Make sure that the weight of the laundry is
suitable for the duration of the program.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in the
washing machine again.
Ensure that the room temperature is higher than
+5°C and lower than +35°C. Optimal room
temperature is 19°C to 24°C.
Set the Time Drying or the Extra Dry program. (It
can happen that some area remains humid when
drying big items (e.g. bed sheets ))
If you want to set a new program, deactivate and
activate the appliance.
".
Make sure that the options are suitable for the
program.
Alarm Code:
The appliance door is open or not
closed correctly. Please check the
door!
The main supply is unstable. Wait
until the main supply is stable.
No communication between
electronic elements of the appli-
ance. Switch off and switch on
again.
Water pressure too low - please check that the
water pressure is between 200 kPa and 800
kPa.
23