AEG ADS854R5SB 사용자 설명서 - 페이지 24

{카테고리_이름} AEG ADS854R5SB에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG ADS854R5SB 32 페이지.

페이지 인쇄

www.aeg.com

Problem

No water goes out from Nozzle,

when "Vapour Refresh" cycle is

selected.

Clothes are slightly damp after

using "Vapour Refresh" cycle.

9.2 If the drying results are not

satisfactory

• The set program was incorrect.

• The filter is clogged.

• There was too much laundry in the

appliance.

• The drum is dirty.

• Room temperature is too low or too

high ( optimal room temperature 19°C

to 24°C )

• You have used wet clothes with

"Vapour Refresh" program.

The "Vapour Refresh" program

reduces wrinkle on dry

laundry only. It is not a drying

program.

Possible solution

The water tap is closed, please open the water

tap.

The inlet hose is squashed or kinked, please

check inlet hose connection.

The filter in the inlet hose is blocked, please

clean the inlet hose filter. Refer to relevant

paragraph in " Care And Cleaning" section.

The Nozzle is clogged, please contact the

Service Centre.

Contact the Service Centre if you are still having

problems.

This is Normal. Vapour Refresh uses moisture to

reduce the wrinkle on fabrics. It is recommended

to hang clothes after using this cycle.

If your laundry feels wet rather than slightly

damp, then the household water pressure is too

high. You may need to reduce pressure by

installing a pressure reducing valve at mains

water connection to the household. This must be

done by qualified plumber.

Note: High water pressure is harmful to all

appliances in your household that are connected

to the water supply ie: washing machine,

dishwasher... etc.