AEG LAVATHERM 57810 사용자 정보 - 페이지 21
{카테고리_이름} AEG LAVATHERM 57810에 대한 사용자 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG LAVATHERM 57810 32 페이지. Condensation dryer
AEG LAVATHERM 57810에 대해서도 마찬가지입니다: 사용자 정보 (32 페이지)
페이지 인쇄
Problem
Drying results unsatis-
factory.
Loading door does not
open with DOOR but-
ton.
Loading door does not
close.
When a button is
pressed, Err appears
in the multi-display.
Drum light does not
work.
PROGRAMME TIME
display changes errati-
cally or stays un-
changed for a long
time.
Programme inactive,
EMPTY WATER display
illuminated.
Possible cause
Wrong programme selected.
Lint filter clogged.
Heat exchanger clogged
with lint.
Overloading of laundry.
Ventilation slots in base area
covered up.
Residue on inside surface of
drum or drum ribs.
Mains plug disconnected.
Programme selector in OFF
position.
Fine strainer not in place
and/or large mesh filter not
locked in place.
Washing protection. After
the start of the programme,
the option can no longer be
set.
Programme selector in OFF
position.
Defective light bulb.
Programme time is correct-
ed automatically depending
on type and volume of
laundry and level of damp-
ness.
Condensate tank is full.
Remedy
Select a different programme
the next time you dry (see
"Overview of programmes"
section).
Clean lint filter.
Clean heat exchanger.
Observe recommended load-
ing volumes.
Uncover ventilation slots in
base area.
Clean inside surface of drum
and drum ribs.
Make an adjustment using the
INTENSITY function (see chap-
ter "Drying, Selecting addi-
tional functions").
Plug in at mains socket.
Set programme. Loading door
can be opened at any time by
exerting pressure on the door.
Install fine strainer and/or
snap large mesh filter into
place.
Turn the programme knob to
OFF. Set the programme again.
Turn programme selector to
LIGHT or to any programme.
Replace light bulb (see next
section).
Automatic process; this is not
a machine fault.
Empty condensate tank, then
start programme with START/
PAUSE button.
21