AEG LAVATHERM 65270AC 사용자 설명서 - 페이지 13

{카테고리_이름} AEG LAVATHERM 65270AC에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG LAVATHERM 65270AC 24 페이지. Lavatherm 65270ac
AEG LAVATHERM 65270AC에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지)

페이지 인쇄

HINTS AND TIPS

ECOLOGICAL HINTS

• Do not use fabric softener to wash and

then dry. In the tumble dryer laundry

becomes soft automatically.

• Use the condensate as distilled water,

e.g. for steam ironing. If necessary

clean the condensate before (e.g. with

a coffee filter) to remove possible small

pieces of fluff.

• Always keep the airflow slots on the

bottom of the appliance clear.

• Use the load volumes specified in the

programmes chapter.

• Make sure that is good airflow in the

appliance installation position.

• Clean the filter after each drying cycle.

• Spin good the laundry before drying.

WATER HARDNESS AND

CONDUCTIVITY

Water hardness can be different for differ-

ent locations. Water hardness has an ef-

fect on the water conductivity and the op-

eration of the conductivity sensor in the

appliance. If you know the value of the

water conductivity you can adjust the sen-

sor to dry with the better results.

To change the sensor conductivity:

Turn the programme dial to available

programme.

Push at the same time the Delicate

and Anticrease buttons and hold

down until one of the these symbols

go into view on the display:

–

300-600 μS/cm

–

Push the Start Pause button again

and again until you set necessary lev-

el.

To memorise setting push at the

same time the Delicate and Anti-

crease buttons.

low conductivity <300 μS/

moderate conductivity

high conductivity >600 μS/

WATER CONTAINER FULL —

INDICATION

By default the indication LED is always on.

It comes into the view at the end of the

cycle or when the water container is full.

When you use an external equipment to

drain the container, the LED can be off.

To activate or deactivate the indication:

Turn the programme dial to available

programme.

Push at the same time the Delicate

and Delay Start buttons and hold

down until you see the correct set-

ting:

– the LED is off and the symbol

goes into the view - The

LED is permanently off

– the LED is on and the symbol

goes into the view - The

LED is activated

ENGLISH