AEG LAVATHERM 65270AC Gebruikershandleiding - Pagina 13
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AEG LAVATHERM 65270AC. AEG LAVATHERM 65270AC 24 pagina's. Lavatherm 65270ac
Ook voor AEG LAVATHERM 65270AC: Gebruikershandleiding (20 pagina's)
Pagina afdrukken
HINTS AND TIPS
ECOLOGICAL HINTS
• Do not use fabric softener to wash and
then dry. In the tumble dryer laundry
becomes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If necessary
clean the condensate before (e.g. with
a coffee filter) to remove possible small
pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Use the load volumes specified in the
programmes chapter.
• Make sure that is good airflow in the
appliance installation position.
• Clean the filter after each drying cycle.
• Spin good the laundry before drying.
WATER HARDNESS AND
CONDUCTIVITY
Water hardness can be different for differ-
ent locations. Water hardness has an ef-
fect on the water conductivity and the op-
eration of the conductivity sensor in the
appliance. If you know the value of the
water conductivity you can adjust the sen-
sor to dry with the better results.
To change the sensor conductivity:
1.
Turn the programme dial to available
programme.
2.
Push at the same time the Delicate
and Anticrease buttons and hold
down until one of the these symbols
go into view on the display:
–
cm
–
300-600 μS/cm
–
cm
3.
Push the Start Pause button again
and again until you set necessary lev-
el.
4.
To memorise setting push at the
same time the Delicate and Anti-
crease buttons.
low conductivity <300 μS/
moderate conductivity
high conductivity >600 μS/
WATER CONTAINER FULL —
INDICATION
By default the indication LED is always on.
It comes into the view at the end of the
cycle or when the water container is full.
When you use an external equipment to
drain the container, the LED can be off.
To activate or deactivate the indication:
1.
Turn the programme dial to available
programme.
2.
Push at the same time the Delicate
and Delay Start buttons and hold
down until you see the correct set-
ting:
– the LED is off and the symbol
goes into the view - The
LED is permanently off
– the LED is on and the symbol
goes into the view - The
LED is activated
ENGLISH
13