AEG LAVATHERM 8040 TW ELECTRONIC 사용자 정보 - 페이지 23
{카테고리_이름} AEG LAVATHERM 8040 TW ELECTRONIC에 대한 사용자 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG LAVATHERM 8040 TW ELECTRONIC 32 페이지. Condenser dryer with heat pump
Problem
Drying cycle ends
shortly after pro-
gramme starts. END
(ENDE) display illumi-
nated.
Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle com-
plete").
Changing bulb for inside light
Only use a special bulb which is designed specially for dryers. The spe-
cial bulb is available from the after-sales service,
ET-Nr. 112 552 000-5.
3
Important: When the appliance is switched on, the interior lighting
switches itself off after 5 minutes when the door is open.
1
Warning! Do not use standard bulbs! These develop too much heat and
may damage the machine!
1
Warning! Before replacing the bulb, disconnect the mains plug; with a
permanent connection: fully unscrew or deactivate the fuse.
1. Unscrew covering bonnet from above bulb (this can be found directly
behind the loading aperture, at the top; refer to "Description of ma-
chine" section.)
2. Replace defective bulb.
3. Screw covering bonnet back down.
1
Warning! For reasons associated with safety, the covering bonnet must
be screwed down tightly. If this is not done, the dryer must not be op-
erated.
Possible cause
Not enough washing load-
ed or washing loaded is too
dry for selected programme.
Lint filter clogged.
Fluff filter blocked with
fluff.
Load volume too big.
Laundry insufficiently pre-
drained.
Particularly high room
temperature. Temporary
switching off of the
compressor to avoid
overload.
Remedy
Select time programme or
higher drying level (e.g. INTEN-
SIVE DRY [STARKTROCKEN] in-
stead of STORAGE DRY
[SCHRANKTROCKEN]).
Clean lint filter.
Clean the fluff filter.
Reduce load volume.
Laundry must be adequately
pre-drained.
Automatic process, there is no
fault with the appliance. If
possible, lower the room
temperature.
23