AEG LAVATHERM T57800 사용자 정보 - 페이지 21
{카테고리_이름} AEG LAVATHERM T57800에 대한 사용자 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG LAVATHERM T57800 30 페이지. Condensation dryer
페이지 인쇄
125987210.qxp
2006-12-04
Problem
Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle complete").
Drying cycle ends
shortly after programme
starts.
END display illu-
minated.
Changing bulb for inside light
Only use a special bulb which is designed specially for dryers. The special bulb
is available from the after-sales service, ET-Nr. 112 552 000-5.
Warning! Do not use standard bulbs! These develop too much heat and
may damage the machine!
Warning! Before replacing the bulb, disconnect the mains plug; with a
permanent connection: fully unscrew or deactivate the fuse.
1. Unscrew covering bonnet from above bulb (this can be found directly behind
the loading aperture, at the top; refer to "Description of machine" section.)
2. Replace defective bulb.
3. Screw covering bonnet back down.
Warning! For reasons associated with safety, the covering bonnet must
be screwed down tightly. If this is not done, the dryer must not be operated.
10:13
Page 21
Possible cause
Lint filter clogged.
Heat exchanger clogged
with lint.
SPECIAL CARE
button pressed and load
volume too big.
Load volume too big.
Laundry insufficiently pre-
drained.
Not enough washing loaded
or washing loaded is too
dry for selected programme.
Remedy
Clean lint filter.
Clean heat exchanger.
SPECIAL CARE is only
suitable for use with
loads of up to 3 kg!
Reduce load volume.
Laundry must be adequately
pre-drained.
Select time programme or
higher drying level (e.g.
INTENSIVE DRY instead
of
STORAGE DRY).
21