AEG TR819P4B 사용자 설명서 - 페이지 22
{카테고리_이름} AEG TR819P4B에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG TR819P4B 32 페이지.
페이지 인쇄
22
www.aeg.com
To clean you can use harder side of
dish-washing sponge and bit of vinegar
or dish soap.
To clean the sensor:
1. Open the loading door.
2. Clean the surfaces of the humidity
sensor wiping off the metal surface
several times.
10.5 Cleaning the drum
WARNING!
Disconnect the appliance
before you clean it.
Use a standard neutral soap detergent to
clean the inner surface of the drum and
11. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
11.1 Error Codes
The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the table). If the problem persists,
contact the Authorised Service Centre.
WARNING!
Deactivate the appliance before carrying out any check.
In case of major problems, the acoustic signals operate, the display shows an
error code and the Start/Pause button may flash continuously:
Error code
E50
Possible cause
Appliance motor overloaded.
Too much laundry or entrap in the
drum.
drum lifters. Dry the cleaned surfaces
with a soft cloth.
CAUTION!
Do not use abrasive
materials or steel wool to
clean the drum.
10.6 Cleaning the control
panel and housing
Use a standard neutral soap detergent to
clean the control panel and housing.
Use a moist cloth to clean. Dry the
cleaned surfaces with a soft cloth.
CAUTION!
Do not use furniture cleaning
agents or cleaning agents
which can cause corrosion.
10.7 Cleaning the airflow
slots
Use a vacuum cleaner to remove fluff
from the airflow slots.
The programme was not comple‐
ted. Remove the laundry from the
drum, set the programme and re‐
start the cycle.
Remedy