AEG TR819P4B 사용자 설명서 - 페이지 23

{카테고리_이름} AEG TR819P4B에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG TR819P4B 32 페이지.

페이지 인쇄

Error code

Internal fail. No communication be‐

tween electronic elements of the

appliance.

E90 or E91

The mains supply is unstable.

EH0

If the display shows other error codes, deactivate and activate the appliance. If the

problem continues, contact the Authorised Service Centre.

In case of different problem with the tumble dryer check the table below for possible

solutions.

11.2 Troubleshooting

Problem

The tumble dryer is not connected

to the mains supply.

The door is open.

The tumble dry‐

er does not op‐

The On/Off button was not pushed. Push the On/Off button.

erate.

The Start/Pause button was not

touched.

The appliance is in standby mode.

Possible cause

Remedy

The programme was not finished

properly or the appliance stoped

too early. Switch the appliance off

and on again.

If the error code appears again,

contact the Authorised Service

Centre.

When the appliance is showing

EH0, please wait until main supply

is stable than press start. If the ap‐

pliance pause the cycle without

any indication then press the cycle

start. If the warning will occur

check the power cord / socket in‐

tegrity or main supply.

Remedy

Connect it to the mains socket.

Check the fuse in the fuse box (do‐

mestic installation).

Close the door.

Touch the Start/Pause button.

Push the On/Off button.

ENGLISH