Kohler K-1164 설치 매뉴얼 - 페이지 10

{카테고리_이름} Kohler K-1164에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler K-1164 44 페이지. Bath with airjets
Kohler K-1164에 대해서도 마찬가지입니다: 주택 소유자 매뉴얼 (32 페이지), 주택 소유자 매뉴얼 (29 페이지), 설치 매뉴얼 (48 페이지), 주택 소유자 매뉴얼 (36 페이지), 러프인 매뉴얼 (4 페이지), 설치 및 관리 매뉴얼 (21 페이지), 주택 소유자 매뉴얼 (29 페이지)

Make sure air actuator tubing is

securely attached to the pump.

Bond in accordance with applicable codes.

NOTE: Pump model illustrated may differ from your

actual product.

8. Make Electrical Connections

WARNING: Risk of electrical shock. To reduce the risk of electrical shock, connect the pump to a

properly grounded Ground-Fault Circuit-Interrupter (GFCI). This will provide additional protection

against line-to-ground shock hazard. A 120 V, 15 A dedicated circuit is required.

WARNING: Risk of electrical shock. Make sure the power has been disconnected before performing

the following procedures.

Locate and secure the supplied junction box a minimum of 1-1/2" (3.8 cm) above the subﬂoor.

The whirlpool controls and system have been prewired at the factory. A licensed electrician should

make a routine service connection to the junction box.

Connect service to the junction box. The 60 Hz model junction box contains black and white wires

and a ground lug.

A 120 V, 15 A dedicated circuit is required. Provide a Class A Ground-Fault Circuit-Interrupter

(GFCI).

Provide a separate equipment grounding conductor for the inside ground or ground lug. The

conductor must not be connected to any current-carrying conductor.

Bond in accordance with national and local codes.

1010914-2-D

Pump

Electrical

Cord

Junction box should be

wired as shown.

Ground

Neutral

(White)

Electrician to

provide suitable

Neutral

strain relief.

Wire Connectors

From Pump

Line

(Black)

Line

Kohler Co.