Kohler KD 500 워크샵 매뉴얼 - 페이지 34

{카테고리_이름} Kohler KD 500에 대한 워크샵 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler KD 500 44 페이지. 51267

Engine assembly

- 34 -

Camshaft

Insert the tappets into their housings on the casing. Mount the

camshaft, matching the reference marks on the gears (fig.60).

Place a calibrated bar on the casing, on a level with the timing

system cover retention surface and use a thickness gauge to

check the distance between the gear and bar (fig. 61). Note

down the value measured.

Place a calibrated bar on the cover of the timing system, on

a level with the engine casing retention surface and use a

thickness gauge to check the distance between the bearing ring

and bar (fig. 62).

Note down the value measured.

The sum of the two measured values must be within:

Place a calibrated bar on the casing, on a level with the timing

system retention cover and use a thickness gauge to check the

distance between the gear and bar (fig. 63). The value must be

between:

Workshop Manual KD500 _ cod. ED0053029390 - 1° ed_rev. 00

0,10 ÷ 0,30 mm

0,10 ÷ 0,25 mm