Kohler SNOWPRO WH208 소유자 매뉴얼 - 페이지 5
{카테고리_이름} Kohler SNOWPRO WH208에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler SNOWPRO WH208 17 페이지. Horizontal crankshaft
Kohler SNOWPRO WH208에 대해서도 마찬가지입니다: 서비스 매뉴얼 (12 페이지)
페이지 인쇄
Fuel Recommendations
Explosive Fuel can cause fires
and severe burns.
Do not fill the fuel tank while the
engine is hot or running.
Gasoline is extremely flammable and its vapors can explode
if ignited. Store gasoline only in approved containers, in
well ventilated, unoccupied buildings, away from sparks or
flames. Do not fill the fuel tank while the engine is hot or
running, since spilled fuel could ignite if it comes in contact
with hot parts or sparks from ignition. Do not start the
engine near spilled fuel. Never use gasoline as a cleaning
agent.
General Recommendations
Purchase gasoline in small quantities and store
in clean, approved containers. A container with a
capacity of 2 gallons or less with a pouring spout is
recommended. Such a container is easier to handle and
helps eliminate spillage during refueling.
Do not use gasoline left over from the previous season,
to minimize gum deposits in your fuel system and to
ensure easy starting.
Do not add oil to the gasoline.
Do not overfill the fuel tank. Leave room for the fuel to
expand. Do not fill above the base of the filler neck.
Fuel Type
For best results use only clean, fresh, unleaded gasoline
with a pump sticker octane rating of 87 or higher. In
countries using the Research method, it should be 90
octane minimum.
Unleaded gasoline is recommended as it leaves
less combustion chamber deposits and reduces
harmful exhaust emissions. Leaded gasoline is not
recommended.
WARNING
Gasoline/Alcohol blends
Gasohol (up to 10% ethyl alcohol, 90% unleaded
gasoline by volume) is approved as a fuel for Kohler
engines. Other gasoline/alcohol blends including E20
and E85 are not to be used and are not approved. Any
failures resulting from use of these fuels will not be
warranted.
Gasoline/Ether blends
Methyl Tertiary Butyl Ether (MTBE) and unleaded
gasoline blends (up to a maximum of 15% MTBE by
volume) are approved as a fuel for Kohler engine.
Other gasoline/ether blends are not approved. Any
failures resulting from use of these fuels will not be
warranted.
Operating Instructions
Also read the operating instructions of the equipment this
engine powers.
Pre-Start Checklist
• Check oil level. Add oil if low. Do not overfill.
NOTE: Engines are shipped without oil. Do not start
engine with no or low oil. This will cause
damage to the engine and will not be covered
under warranty.
• Check fuel level. Add fuel if low.
• Check cooling air intake areas and external
surfaces of engine. Make sure they are clean and
unobstructed.
• Check that all shrouds, equipment covers, and
guards are in place and securely fastened.
• Check that any clutches or transmissions are
disengaged or placed in neutral. This is especially
important on equipment with hydrostatic drive.
The shift lever must be exactly in neutral to
prevent resistance which could keep the engine
from starting.
5