Kohler SNOWPRO WH208 소유자 매뉴얼 - 페이지 7
{카테고리_이름} Kohler SNOWPRO WH208에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler SNOWPRO WH208 17 페이지. Horizontal crankshaft
Kohler SNOWPRO WH208에 대해서도 마찬가지입니다: 서비스 매뉴얼 (12 페이지)
페이지 인쇄
Figure 8. Operating the Retractable Starter.
NOTE: Extend the starting rope periodically and
check its condition. If the rope is frayed,
have it replaced immediately by your Kohler
Engine Service Center.
Electrical Shock can cause severe
injury or death.
Use only a 3 wire extension cord with
a Ground Fault Circuit Interrupter
(GFCI) outlet.
Use only a 3-wire extension cord and Ground Fault Circuit
Interrupter (GFCI) outlet. Plug into the engine first then the
wall outlet. After starting, remove cord from wall outlet first,
then remove from the electric starter.
For (Optional) Electric Start – First plug the
3-wire extension cord into the electric start
receptacle and then into a Ground Fault Circuit
Interrupter (GFCI) wall outlet. Press the starter
button. See Figure 9. DO NOT hold the starter
button in for more than 10 seconds. Wait one full
minute between start attempts. If engine does not
start after 4 attempts refer to Troubleshooting
Chart.
Electric
Start
Receptacle
Figure 9. Electric Starter, Receptacle and Starter
Button (Optional).
Starter
Handle
WARNING
Starter
Button
Electric
Starter
5. Gradually return the choke control to the RUN/
OFF position after the engine starts and warms
up. See Figure 10.
The engine/equipment may be operated during
the warm up period, but it may be necessary
to leave the choke partially on until the engine
warms up.
RUN/OFF
Figure 10. RUN/OFF Position of Choke Control.
Normal Stopping
1. If possible, remove the load.
2. Move the throttle control to the SLOW or LOW
idle position. Allow the engine to run at idle for
30-60 seconds. See Figure 11.
3. Turn the fuel shut-off valve to the OFF position.
See Figure 13.
4. Brush snow off engine and equipment.
FAST
SLOW
STOP
Figure 11. STOP Position of Throttle Control.
CHOKE/ON
Choke
Control
Throttle
Control