Acadian Robotics Copperhead 조립 설명서 - 페이지 13
{카테고리_이름} Acadian Robotics Copperhead에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Acadian Robotics Copperhead 15 페이지.
페이지 인쇄COPPERHEAD 3D PRINTER ASSEMBLY GUIDE
12
- Use caution when handling the PCB. Ensure that you are grounded as to
not transmit any static to the PCB.
- When inserting the extruder heater wire, cooling fan wire, and heatbed
heater wire do not twist the bare ends of the wire together. It will make it
more difficult to insert. Gently guide the wires into the pins and use a
small flathead screwdriver to secure the wiring in place.
- The wires for the extruder heater and heatbed heater can be inserted into
the + or – pins. The cooling fan wire needs to match the respective
polarity for the cooling fan to work properly.
- The limit switch and thermostat wires can be inserted either way but
must be inserted into the correct pins as shown.
- The X, Y, and E motor wires should be inserted with the closed end of the
connector facing the top of the PCB as viewed in the picture above.
Step 2: Power supply wiring