- ページ 13

3Dプリンター Acadian Robotics CopperheadのPDF 組立マニュアルをオンラインで閲覧またはダウンロードできます。Acadian Robotics Copperhead 15 ページ。

COPPERHEAD 3D PRINTER ASSEMBLY GUIDE

- Use caution when handling the PCB. Ensure that you are grounded as to

not transmit any static to the PCB.

- When inserting the extruder heater wire, cooling fan wire, and heatbed

heater wire do not twist the bare ends of the wire together. It will make it

more difficult to insert. Gently guide the wires into the pins and use a

small flathead screwdriver to secure the wiring in place.

- The wires for the extruder heater and heatbed heater can be inserted into

the + or – pins. The cooling fan wire needs to match the respective

polarity for the cooling fan to work properly.

- The limit switch and thermostat wires can be inserted either way but

must be inserted into the correct pins as shown.

- The X, Y, and E motor wires should be inserted with the closed end of the

connector facing the top of the PCB as viewed in the picture above.

Step 2: Power supply wiring