Kohler 14RESA 설치 및 작동 지침 매뉴얼 - 페이지 9

{카테고리_이름} Kohler 14RESA에 대한 설치 및 작동 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler 14RESA 37 페이지. Residential/commercial generator sets
Kohler 14RESA에 대해서도 마찬가지입니다: 설치 지침 (4 페이지), 문제 해결 매뉴얼 (8 페이지), 설치 지침 (2 페이지), 운영 (20 페이지)

페이지 인쇄

13. See Figure 9 and Figure 12. Carefully remove the

knockouts for the circuit breakers in the inner cover

of the enclosure:

a. Remove the larger portion on the left side of

each knockout for the 70 amp breakers

(14RESA and 14RCA) OR

b. Remove both portions of the knockout for the

100 amp breakers (20RESA/B/C/D and

20RCA).

1. Remove only this portion for 70 amp breakers

2. Remove both portions for 100 amp breakers

Figure 12 Circuit Breaker Knockouts

14. The decals shown in Figure 13 are provided in the

literature bag with the APM.

GENERATOR 1

and

above the circuit breakers as shown in Figure 9.

15. Attach the Service Disconnect decals to the

outside of the inner cover near the openings for the

circuit breakers. Be sure to correctly label the

breakers for Generator 1 and Generator 2. See

Figure 13 and Figure 9.

16. Close the circuit breakers between the APM and

the generator sets.

The inner door for the APM enclosure will be installed

later.

TT-1596

8/22

GM85144

Attach the

GENERATOR 2

decals

Figure 13 Decals provided with APM

1.4 Install the Model RXT transfer switch.

Note: Only one transfer switch can be used.

17. Install the ATS according to the installation

instructions and dimension drawings in the transfer

switch Installation Manual.

18. Do not connect the emergency source wiring or the

RBUS connections until instructed later in this

procedure.

1.5 Install the LCM or load shed kit and

optional PIM, if used.

Note: One PIM and one load management device

can be used. Multiple PIMs, LCMs, or load

shed kits cannot be connected.

19. Follow the installation instructions provided with

PIM and LCM or load shed kit(s). If the RXT ATS

with combined interface board is used for load

management, follow the instructions in TP- 6807,

RXT Operation and Installation Manual, to connect

the load management circuits.

Note: Connect sufficient non-critical loads to the

load management device so that one

generator set can support the remaining

load, if necessary.

Note: Do not install the CT provided with the LCM,

load shed kit, or RXT with combined board.

That CT is not needed, as the generator

controllers each have built-in metering with

the locally mounted CT that was installed in

Section 1.1.

GM85148